The balloon pilot conducted multiple sport parachute flights throughout the day without
obtaining a weather briefing. A SIGMET for severe thunderstorms, hail, and cloud tops to
45,000 feet was in effect for the area surrounding the takeoff and accident sites. Shortly after
the balloon lifted off on the accident flight, the ground crew was advised of a severe storm
warning for the area and observed the storm on radar via their cellular telephones. The crew
contacted the pilot by radio to advise him that the storm was growing quickly. The pilot
informed the ground crew that he would attempt to climb over the storm but shortly thereafter
expressed doubts that the balloon would be able to rise over it.
Category: State
The pilot stated that, before starting the engine by manually rotating the propeller, he set the
brakes, throttle, and trim. He exited the airplane and proceeded to rotate the propeller. When
the engine started, it went to full rpm, and the airplane started to move forward on the taxiway
at a high speed. The airplane veered off the taxiway and continued its high speed taxi until it
impacted a hangar door, damaging the engine, both wings, and the right main landing gear.
The pilot reported that he had not chocked the airplane and thought the brake was set. He
further reported there were no mechanical problems with the airplane.
Prior to the flight, the pilot fueled the airplane with 16 gallons of jet fuel. He planned to make two local flights carrying skydivers aloft. During the second skydiving flight, he delayed releasing the skydivers due to traffic in the area. As he turned the airplane back toward the drop zone, the airplane’s engine experienced a total loss of power.
The pilot reported that he was descending to land after his final flight of the day. The airplane was about 1,500 to 1,700 feet above ground level and about 1.25 miles from the airport when the engine lost total power. The pilot made an emergency landing to an open field, and the airplane sustained substantial damage to the fuselage.
The pilot stated that he was descending the airplane from an altitude of 8,000 feet after releasing skydivers. During the descent, at an altitude of about 3,000 feet, the airplane’s door opened and contacted the underside of the wing. The pilot slowed the airplane and attempted to close the door but noticed that the door had warped and that the window was missing.
While landing, the airplane touched down short of the runway, the left main landing gear impacted the edge of the runway and collapsed, and the airplane departed the edge of the runway into a culvert. The airplane’s left wing sustained substantial damage.
On August 9, 2011, about 1714 mountain daylight time, a Cessna 182, N8718T, landed in a field while on approach to Boulder Municipal Airport (KBDL). The aircraft was substantially damaged and came to rest after striking a tree on the north side of the field.
The pilot stated that he fueled the airplane for two flights with skydivers and thirty minutes of reserve fuel. He further stated that during the second approach he had to adjust his intended flight path for other airplane traffic. Then, as the pilot decreased the pitch of the airplane on final approach, the engine sputtered and lost power.
According to the pilot, as he taxied the airplane to the runway for takeoff, the left main landing gear collapsed. Examination revealed that the left main landing gear had fractured and completely separated from the airplane about 6 inches outboard of its attachment point at the airframe.
The pilot of the skydiving airplane was performing the first takeoff of the day, and he had just raised the landing gear when the airplane experienced a complete loss of power in one of its two engines. There was still runway remaining, and the pilot made the decision to abort the takeoff.
During takeoff the airplane, which was taking off for a parachute jump, collided with trees lining the side of the grass runway. The pilot said that a previous flight that day had been uneventful. During the accident takeoff he said he heard a “pop” at rotation and the airplane pulled to the left.
The pilot received an unsafe landing gear indication for the left main landing gear when he configured the airplane for landing. He cycled the gear and then attempted a manual extension, both without success. The pilot then completed the landing on the nose and right main landing gear. A post accident examination of the left main landing gear actuator revealed that the supports for the actuator bearings lacked lubrication and that the bearings displayed wear due to inadequate lubrication.
The pilot flew four skydiving flights without refueling. On the last flight, after the skydivers exited the airplane, the pilot initiated a descent and the airplane experienced a total loss of engine power. The pilot knew he could not make it back to the airport and made a forced landing to a gravel area.
The airplane had not been flown for about 5 months and the purpose of the accident flight was a maintenance test flight after both engines had been replaced with higher horsepower models. Witnesses observed the airplane depart and complete two uneventful touch-and-go landings. The airplane was then observed to be struggling to gain altitude and airspeed while maneuvering in the traffic pattern.
The flight departed to the east with four skydivers for a local jump. One witness stated that, immediately following the takeoff, about 200 feet above ground level, a “percussive” pop from the engine was heard. Two witnesses stated that the right wing dropped, and the airplane impacted the ground.
The airplane was departing for a skydiving flight. During rotation, the jump door opened, which was located on the right side of the airplane. The pilot said that he was not concerned with the door, which would not have critically impacted the airplane’s performance; however, an experienced parachutist attempted to secure the door to the point where he was partially outside of the airplane.
During flight at 10,000 feet above ground level, the engine began to vibrate and run rough. Shortly thereafter, a loud bang occurred and oil was present on the windscreen. The pilot attempted a forced landing, and during the forced landing, the airplane landed short of the runway and impacted a ditch.
The Beech King Air had undergone maintenance that included a landing gear disassembly and inspection in preparation for the airplane’s sale. Following the landing gear inspection, the left main landing gear strut was overfilled to an extension that exceeded maintenance specifications due to the strut not being able to maintain the manufacturer’s specified pressure/extension.
The pilot was departing from a soft, dry, 2,200-foot turf airfield using soft/short field procedures. After becoming airborne, the airplane settled back onto the runway, became airborne, and settled onto the runway a second time. At this time the right main wheel separated and the landing gear strut dug into the terrain spinning the airplane around and bringing it to an abrupt stop.
The airplane landed from a skydiving flight with a remaining passenger after three parachutists had jumped from the airplane. The engine was not shut down and the airplane was pointed toward the vehicle waiting for the passenger to deplane. When the passenger exited the airplane, a ground crewmember leaned toward the airplane to talk to the pilot while the passenger went around the right side of the airplane.
During a skydiving flight at approximately 14,000 feet, an instructor positioned himself at the door opening with his jump student nearby. The student inadvertently pulled the instructor’s reserve parachute D-ring, deploying the chute and pulling the instructor out of the airplane
The pilot stated that after the 20 skydivers left the airplane, he “descended and entered at a 45-degree angle for the downwind leg for landing on runway 08.” Once on the downwind leg of the traffic pattern, the pilot stated that the “windshield began fogging up.” The pilot decided to make a 360-degree turn to the right while he wiped the window with a rag.
The pilot stated that after departure and climbing to approximately 200 feet, the engine lost power and the airplane began to descend. During the forced landing the airplane struck a power line and impacted terrain resulting in substantial damage.
The airplane used for the skydiving operation was equipped with a foot step just above the right wheel, which the skydivers used to launch from the airplane. As the last of four skydivers stepped on the foot step, the right main landing gear fell away. The pilot reported that after he flew around for about 1 1/2 hours to burn off fuel, he intended to perform a low pass over the runway before coming around to land.
The non-instrument rated private pilot planned to attend a skydiving event near the destination airport that began the next day. Prior to departure, the pilot was aware of the low clouds affecting the destination airport. The pilot told an acquaintance at the destination airport that he needed to make the flight that night because of deteriorating weather conditions that were expected on the next day.