The pilot of a Piper L-4 airplane reported that shortly after he started the taxi roll from the parking area, he initiated a shallow turn toward the taxiway. As he reached the taxiway he steered to follow the centerline, however, the airplane continued to turn to the right. He reported, in part, that the left brake inputs were not responsive and the airplane continued to the right and collided with a standing occupied Cessna.
Category: Non-Fatal Single-Engine
The private pilot stated that he was at an altitude of 3,500 feet when the engine stopped producing power. He made a forced landing to field and struck a cedar post with the airplane’s nose wheel and subsequently flipped over resulting in structural damage to the vertical stabilizer
The airplane was fueled before the pilot’s first flight that day. A total of 6.0 gallons of fuel were added to each fuel tank. After fueling, the pilot dipped each fuel tank using the provided dipstick, and determined that each tank contained between 7.0 and 7.5 gallons of usable fuel. He then flew one load of skydivers, returned, and attempted to secure the engine for fueling but was pressured by company personnel that he had enough fuel to make the second flight and that he needed to keep the airplane operating.
The helicopter impacted unmarked power transmission lines as the pilot maneuvered at a low altitude over a river. The helicopter impacted the river and separated into several pieces. The pilot and his passengers were not injured and were rescued by nearby boaters.
The pilot flew nine skydiving flights on the day of the accident in the Cessna 182A. Each flight was approximately 30 minutes in duration. The airplane was refueled after approximately every other flight with about 12 gallons of fuel. Prior to takeoff for the tenth and final flight of the day, the pilot thought he had about 16 gallons of fuel in the airplane; however, he did not visually confirm how much fuel was in the tanks and could not remember what the fuel gauges indicated.
The pilot landed on runway 33, which is a dirt runway. The wind direction at the time was 320 degrees at 19 knots, gusting to 29. The pilot turned the airplane around to back taxi to parking. While back taxiing, the airplane’s nose wheel encountered a soft spot of sand, and the pilot added some power to get through the soft spot. The tail came up, and the airplane nosed over.
The pilot reported that the airplane, which was used for sky diving operations, was climbing through 7,000 feet mean sea level (msl) when he heard an explosion followed by a metal grinding noise coming from the engine section of the airplane. He felt the airplane vibrate, and smoke began to fill the cabin. He reported that the engine was not producing any power so he shut the fuel off and performed procedures to rid the cabin of smoke.
The pilot was returning to the departure airport following the release of skydivers. The airplane was on a straight in approach to the runway during windy conditions when the engine lost power. The pilot applied full throttle but the engine did not respond.
The pilot was returning to the airport after releasing some skydivers. He was following a training airplane in the traffic pattern and was gaining on it, so he decided to extend his downwind leg. On final approach to runway 08, his airplane was still gaining on the other airplane. The pilot reduced power and raised the nose to reduce airspeed to 85 mph.
The commercial pilot was climbing the airplane with four skydivers aboard when the engine lost power. The pilot told the skydivers to jump when he could not restart the engine, and they all jumped successfully without injury. The pilot made a forced landing short of the departure runway, and the airplane collided with small trees, sustaining substantial damage to the wings and fuselage.
Following three days of rain, the pilot attempted a soft field takeoff from a turf runway. The pilot reported that as the airplane was “sliding” down the runway he observed something on the windscreen that resembled oil, followed by a decrease in engine oil pressure.
The pilot checked the fuel quantity with a wooden stick and estimated 21 gallons of fuel was onboard for the parachute flight. The takeoff and climb to 10,000 feet msl, and release of the jumpers, was normal. On the return to the airport, while on the turn to base leg, the engine lost power.
After releasing skydivers, the pilot was descending the airplane from 11,000 feet and returning to his home airport. He utilized carburetor heat while descending to 3,000 feet, and everything seemed normal during the approach to the 3,999-foot-long asphalt runway. The bounced upon landing and the pilot initiated a go-around; however, the airplane experienced a loss of engine power during the initial climb, about 50 to 75 feet above ground level (agl).
The pilot stated she had been conducting parachute drop operations through out the day. The pilot departed on the last parachute drop flight at an undetermined time, completed the parachute drop, and descended with power on. The pilot did not apply carburetor heat during the descent because the carburetor heat control cable was stuck, and would not move for the last two days.
According to the pilot of the Cessna 182A, he was returning to land after completing a skydiving drop. The descent, and the downwind and base legs of the traffic pattern were uneventful; however, after turning onto the final leg, the pilot attempted to add power, and the engine “cut out.”
The 568-hour commercial pilot was returning to a private airstrip for a night landing after releasing parachute jumpers. According to the Pilot/Operator Aircraft Accident Report (NTSB Form 6120.1/2) the aircraft’s landing light was inoperative so in an attempt to identify the unlit grass runway, the pilot flew over the area several times to try to find the airstrip.
The airplane failed to gain altitude and settled into the ground during the takeoff initial climb. The firewall buckled during the ground contact. The pilot said that just after takeoff, the airspeed decreased to 60 knots and the airplane was 300 feet above ground level. He was unable to recover the airspeed and he touched down in a field.
The pilot reported that shortly after reaching an altitude of 400 feet agl after takeoff, the engine quit suddenly. He immediately pumped the throttle two times, and turned on the auxiliary fuel pump, but this did not restore engine power. He made a hard forced landing in an industrial park near the airport.
According to the pilot, she dropped her load of skydivers and was coming in for a landing. She “could see fog rolling in fast” and knew she “had to get…on the ground.” She “landed at a higher speed which is normally fine but because of the runway conditions, which were slick, [she] had minimal braking and ran out of runway.”
The Cessna 182, operating as a platform for skydiving operations, sustained substantial damage during a skydiving flight. The commercial pilot reported a skydiver’s reserve parachute accidentally deployed while the skydiver was getting established on the step before jumping from the airplane.
The airline transport certificated pilot with 10 skydiving passengers began a takeoff in a tailwheel-equipped and turboprop powered airplane on a CFR Part 91 skydiving flight. As the airplane started its climb, the pitch angle of the nose of the airplane increased until the airplane appeared to stall about 50 to 100 feet agl. It descended and impacted the runway in a left wing, nose low attitude.
The airplane took off with its third lift of skydivers for the day. The engine began to run roughly at rotation, and due to the speed of the airplane, and the lack of remaining runway, the pilot elected to continue the takeoff. The pilot initially turned toward a public roadway for a forced landing, but the airplane continued to climb under partial power, so he maneuvered back to the airport for a downwind landing on the runway.
The airplane lost engine power and collided with terrain during the forced landing. Prior to the second flight of the day the pilot fueled the airplane’s right wing with approximately 8 gallons of fuel, bringing the total fuel load for the flight to approximately 20 or 21 gallons. The operator of the skydiving operation said that he instructed his pilots to fuel the aircraft after each flight to 21 gallons for a load of 3 or 4 people, and to 19 gallons for a load of 2 people.
The parachute jump plane was substantially damaged when it collided with a parachutist on final approach for landing. The pilot was not able to maintain directional control and the airplane impacted trees and terrain near the airport. The pilot stated that he was on final approach for landing, when a parachutist “made a rapid descent and accelerated from behind [his] right wing.”
The airplane departed about 1130, and the outside air temperature at 1145 was 39 degrees F. The outside air temperature at 0747 was 28 degrees F. The pilot did not preheat the engine, and had difficulty starting it. On the third attempt, the engine started. The pilot then taxied to the runway, performed a rolling run-up, and departed.