The non-instrument rated private pilot planned to attend a skydiving event near the destination airport that began the next day. Prior to departure, the pilot was aware of the low clouds affecting the destination airport. The pilot told an acquaintance at the destination airport that he needed to make the flight that night because of deteriorating weather conditions that were expected on the next day.
Category: C-182
The private pilot stated that he was at an altitude of 3,500 feet when the engine stopped producing power. He made a forced landing to field and struck a cedar post with the airplane’s nose wheel and subsequently flipped over resulting in structural damage to the vertical stabilizer
The airplane was fueled before the pilot’s first flight that day. A total of 6.0 gallons of fuel were added to each fuel tank. After fueling, the pilot dipped each fuel tank using the provided dipstick, and determined that each tank contained between 7.0 and 7.5 gallons of usable fuel. He then flew one load of skydivers, returned, and attempted to secure the engine for fueling but was pressured by company personnel that he had enough fuel to make the second flight and that he needed to keep the airplane operating.
The pilot flew nine skydiving flights on the day of the accident in the Cessna 182A. Each flight was approximately 30 minutes in duration. The airplane was refueled after approximately every other flight with about 12 gallons of fuel. Prior to takeoff for the tenth and final flight of the day, the pilot thought he had about 16 gallons of fuel in the airplane; however, he did not visually confirm how much fuel was in the tanks and could not remember what the fuel gauges indicated.
The pilot landed on runway 33, which is a dirt runway. The wind direction at the time was 320 degrees at 19 knots, gusting to 29. The pilot turned the airplane around to back taxi to parking. While back taxiing, the airplane’s nose wheel encountered a soft spot of sand, and the pilot added some power to get through the soft spot. The tail came up, and the airplane nosed over.
The pilot was returning to the departure airport following the release of skydivers. The airplane was on a straight in approach to the runway during windy conditions when the engine lost power. The pilot applied full throttle but the engine did not respond.
The commercial pilot was climbing the airplane with four skydivers aboard when the engine lost power. The pilot told the skydivers to jump when he could not restart the engine, and they all jumped successfully without injury. The pilot made a forced landing short of the departure runway, and the airplane collided with small trees, sustaining substantial damage to the wings and fuselage.
Following three days of rain, the pilot attempted a soft field takeoff from a turf runway. The pilot reported that as the airplane was “sliding” down the runway he observed something on the windscreen that resembled oil, followed by a decrease in engine oil pressure.
After preflighting the airplane, adding fuel and checking the oil, the pilot radioed that he was taxiing to runway 32. Witnesses subsequently observed the airplane takeoff on runway 32, make a 180-degree turn toward the south, and then fly downwind and parallel to the runway at an altitude of between 300 and 500 feet above ground level. At approximately the end of the runway the airplane was observed making a left turn onto base leg for runway 32, followed by a steep turn to final before nosing into the ground and bursting into flames.
The pilot checked the fuel quantity with a wooden stick and estimated 21 gallons of fuel was onboard for the parachute flight. The takeoff and climb to 10,000 feet msl, and release of the jumpers, was normal. On the return to the airport, while on the turn to base leg, the engine lost power.
After releasing skydivers, the pilot was descending the airplane from 11,000 feet and returning to his home airport. He utilized carburetor heat while descending to 3,000 feet, and everything seemed normal during the approach to the 3,999-foot-long asphalt runway. The bounced upon landing and the pilot initiated a go-around; however, the airplane experienced a loss of engine power during the initial climb, about 50 to 75 feet above ground level (agl).
The pilot stated she had been conducting parachute drop operations through out the day. The pilot departed on the last parachute drop flight at an undetermined time, completed the parachute drop, and descended with power on. The pilot did not apply carburetor heat during the descent because the carburetor heat control cable was stuck, and would not move for the last two days.
According to the pilot of the Cessna 182A, he was returning to land after completing a skydiving drop. The descent, and the downwind and base legs of the traffic pattern were uneventful; however, after turning onto the final leg, the pilot attempted to add power, and the engine “cut out.”
The 568-hour commercial pilot was returning to a private airstrip for a night landing after releasing parachute jumpers. According to the Pilot/Operator Aircraft Accident Report (NTSB Form 6120.1/2) the aircraft’s landing light was inoperative so in an attempt to identify the unlit grass runway, the pilot flew over the area several times to try to find the airstrip.
The Cessna 182, operating as a platform for skydiving operations, sustained substantial damage during a skydiving flight. The commercial pilot reported a skydiver’s reserve parachute accidentally deployed while the skydiver was getting established on the step before jumping from the airplane.
The airplane took off with its third lift of skydivers for the day. The engine began to run roughly at rotation, and due to the speed of the airplane, and the lack of remaining runway, the pilot elected to continue the takeoff. The pilot initially turned toward a public roadway for a forced landing, but the airplane continued to climb under partial power, so he maneuvered back to the airport for a downwind landing on the runway.
The airplane lost engine power and collided with terrain during the forced landing. Prior to the second flight of the day the pilot fueled the airplane’s right wing with approximately 8 gallons of fuel, bringing the total fuel load for the flight to approximately 20 or 21 gallons. The operator of the skydiving operation said that he instructed his pilots to fuel the aircraft after each flight to 21 gallons for a load of 3 or 4 people, and to 19 gallons for a load of 2 people.
The airplane departed about 1130, and the outside air temperature at 1145 was 39 degrees F. The outside air temperature at 0747 was 28 degrees F. The pilot did not preheat the engine, and had difficulty starting it. On the third attempt, the engine started. The pilot then taxied to the runway, performed a rolling run-up, and departed.
The pilot stated that after skydivers exited the aircraft, he began a descent from 10,500 feet msl in the direction of the airport. He stated that upon reaching 2000 feet msl, he enriched the mixture, and the engine lost power. He stated he elected to land on a nearby road. The airplane collided with a pick-up truck and departed the road to the right.
The pilot stated that while the first parachutist was climbing out on the airplanes strut, her pilot chute got caught on a safety belt resulting in the inadvertent deployment of her main parachute, which streamed back over the right horizontal stabilizer. The parachutist went under as the main parachute went over the top of the stabilizer.
The pilot told an FAA inspector that he had completed an air drop of skydivers at 14,000 feet and was returning to land. During the descent, the engine quit. The pilot initially thought it was due to carburetor ice, but then realized that he ran “out of fuel.” The pilot was forced to land the airplane short of the runway.
According to the pilot, after the four parachute jumpers exited the airplane, and as he maneuvered the airplane for a landing, the engine lost power. Initial efforts by the pilot to restore full power were unsuccessful, however as the pilot continued, the engine regained partial power. The pilot entered a straight approach for runway 18
After departure, at an altitude of approximately 500 feet agl, the 2,100-hour pilot reported the engine “lost most of its power output.” The pilot stated he applied carburetor heat and did not notice improvement. The pilot banked the airplane slightly to the right to avoid an approaching tree line and initiated an emergency landing to an open grass field.
After completing a flight with a load of skydivers, the pilot “dipped” the left tank and it indicated 15 gallons of fuel. He then flew another flight to 3,500 feet MSL and started his descent. The pilot reduced power to 1,600 rpm and 16 inches of manifold pressure, and applied full carburetor heat. As the aircraft was approaching pattern altitude, approximately 1,000 AGL, the engine quit without warning.
According to the pilot, he completed an air drop of skydivers and was returning to land. During the final approach, he added power to maintain altitude and obstacle clearance, and the engine “quit without sputter[ing].” He made a forced landing in a sagebrush covered field. The airplane struck the ground, slid down a gully, and struck a tree.