The pilot landed on runway 33, which is a dirt runway. The wind direction at the time was 320 degrees at 19 knots, gusting to 29. The pilot turned the airplane around to back taxi to parking. While back taxiing, the airplane’s nose wheel encountered a soft spot of sand, and the pilot added some power to get through the soft spot. The tail came up, and the airplane nosed over.
Category: Accident Type
The pilot reported that the airplane, which was used for sky diving operations, was climbing through 7,000 feet mean sea level (msl) when he heard an explosion followed by a metal grinding noise coming from the engine section of the airplane. He felt the airplane vibrate, and smoke began to fill the cabin. He reported that the engine was not producing any power so he shut the fuel off and performed procedures to rid the cabin of smoke.
The pilot was landing the twin-engine, turboprop airplane on a 3,000-foot-long, 70-foot-wide, asphalt runway, when he encountered a high sink rate. He applied engine power; however, the engines did not respond quickly enough to prevent a hard landing. During the hard landing, the main landing gear separated and the left landing gear struck the vertical stabilizer. The pilot subsequently performed a go-around and landed on a grass runway, without further incident. The pilot stated that he did not experience any mechanical malfunctions. He reported 5000 hours of total flight experience, which included 500 hours in the same make and model as the accident airplane.
Surviving skydivers said that as the airplane was climbing to the jump altitude of 10,500 feet agl, the stall warning horn sounded intermittently several times. They paid no particular attention to it because they had heard it on previous flights. When the airplane reached the jump altitude, the pilot signaled for one of the parachutists to open the door. When she did, she told the pilot that the airplane had overshot the drop zone by approximately 1 mile.
The pilot was returning to the departure airport following the release of skydivers. The airplane was on a straight in approach to the runway during windy conditions when the engine lost power. The pilot applied full throttle but the engine did not respond.
The pilot of ZK-KAY, a Pacific Aerospace PAC 750XL, was flying under Visual Flight Rules (VFR) on a cross-country flight, tracking south-east, close to Blithfield Reservoir. The pilot and passenger of Luscombe 8E Silvaire Deluxe G-AKUI were on a local flight from their base near the reservoir. G-AKUI entered a turn to the right shortly prior to the collision, possibly to avoid a third aircraft which later radar analysis showed was near.
The pilot was returning to the airport after releasing some skydivers. He was following a training airplane in the traffic pattern and was gaining on it, so he decided to extend his downwind leg. On final approach to runway 08, his airplane was still gaining on the other airplane. The pilot reduced power and raised the nose to reduce airspeed to 85 mph.
The pilot was returning a group of skydivers to their home base after a weekend of skydiving. He flew several jump flights, and then stopped early in the afternoon to prepare the airplane for the flight home. The flight was planned into an area of clouds, turbulence, and icing, which the pilot had researched. He delayed the departure until he decided that he could complete the planned flight under visual flight rules (VFR).
Following an uneventful flight, the pilot overflew the destination airport and observed no apparent wind speed or direction on the windsock. The airplane approached the runway fast, and landed “very hard,” separating the right main landing gear from the airplane in the process.
The commercial pilot was climbing the airplane with four skydivers aboard when the engine lost power. The pilot told the skydivers to jump when he could not restart the engine, and they all jumped successfully without injury. The pilot made a forced landing short of the departure runway, and the airplane collided with small trees, sustaining substantial damage to the wings and fuselage.
The pilot began descending when he thought all jumpers had departed the airplane, but 1 jumper remained. The remaining jumper realized the airplane was descending but was too late to stop his exit. After exiting the airplane he contacted the horizontal stabilizer and broke the femur of his left leg.
Following three days of rain, the pilot attempted a soft field takeoff from a turf runway. The pilot reported that as the airplane was “sliding” down the runway he observed something on the windscreen that resembled oil, followed by a decrease in engine oil pressure.
After preflighting the airplane, adding fuel and checking the oil, the pilot radioed that he was taxiing to runway 32. Witnesses subsequently observed the airplane takeoff on runway 32, make a 180-degree turn toward the south, and then fly downwind and parallel to the runway at an altitude of between 300 and 500 feet above ground level. At approximately the end of the runway the airplane was observed making a left turn onto base leg for runway 32, followed by a steep turn to final before nosing into the ground and bursting into flames.
The pilot checked the fuel quantity with a wooden stick and estimated 21 gallons of fuel was onboard for the parachute flight. The takeoff and climb to 10,000 feet msl, and release of the jumpers, was normal. On the return to the airport, while on the turn to base leg, the engine lost power.
After releasing skydivers, the pilot was descending the airplane from 11,000 feet and returning to his home airport. He utilized carburetor heat while descending to 3,000 feet, and everything seemed normal during the approach to the 3,999-foot-long asphalt runway. The bounced upon landing and the pilot initiated a go-around; however, the airplane experienced a loss of engine power during the initial climb, about 50 to 75 feet above ground level (agl).
The pilot stated she had been conducting parachute drop operations through out the day. The pilot departed on the last parachute drop flight at an undetermined time, completed the parachute drop, and descended with power on. The pilot did not apply carburetor heat during the descent because the carburetor heat control cable was stuck, and would not move for the last two days.
A skydiver jumped up and out of the airplane instead of dropping out of the exit and keeping a low trajectory. He then impacted the horizontal stabilizer and fell away from the leading edge. The skydiver’s automatic deployment system activated and opened the parachute.
On July 29, 2006, about 1345 central daylight time, a de Havilland DHC 6 100, N203E, registered to Adventure Aviation, LLC, and operated by Skydive Quantum Leap as a local parachute operations flight, crashed into trees and terrain after takeoff from Sullivan Regional Airport, near Sullivan, Missouri. The pilot and five parachutists were killed, and two parachutists were seriously injured.
According to the pilot of the Cessna 182A, he was returning to land after completing a skydiving drop. The descent, and the downwind and base legs of the traffic pattern were uneventful; however, after turning onto the final leg, the pilot attempted to add power, and the engine “cut out.”
The 568-hour commercial pilot was returning to a private airstrip for a night landing after releasing parachute jumpers. According to the Pilot/Operator Aircraft Accident Report (NTSB Form 6120.1/2) the aircraft’s landing light was inoperative so in an attempt to identify the unlit grass runway, the pilot flew over the area several times to try to find the airstrip.
The airplane failed to gain altitude and settled into the ground during the takeoff initial climb. The firewall buckled during the ground contact. The pilot said that just after takeoff, the airspeed decreased to 60 knots and the airplane was 300 feet above ground level. He was unable to recover the airspeed and he touched down in a field.
The pilot reported that shortly after reaching an altitude of 400 feet agl after takeoff, the engine quit suddenly. He immediately pumped the throttle two times, and turned on the auxiliary fuel pump, but this did not restore engine power. He made a hard forced landing in an industrial park near the airport.
According to the pilot, she dropped her load of skydivers and was coming in for a landing. She “could see fog rolling in fast” and knew she “had to get…on the ground.” She “landed at a higher speed which is normally fine but because of the runway conditions, which were slick, [she] had minimal braking and ran out of runway.”
The Cessna 182, operating as a platform for skydiving operations, sustained substantial damage during a skydiving flight. The commercial pilot reported a skydiver’s reserve parachute accidentally deployed while the skydiver was getting established on the step before jumping from the airplane.
The airline transport certificated pilot with 10 skydiving passengers began a takeoff in a tailwheel-equipped and turboprop powered airplane on a CFR Part 91 skydiving flight. As the airplane started its climb, the pitch angle of the nose of the airplane increased until the airplane appeared to stall about 50 to 100 feet agl. It descended and impacted the runway in a left wing, nose low attitude.