During a skydiving operation, the aircraft was slowed to slow cruise flight for a parachute jump. As skydivers were moving to the exit door for a group jump, the d-ring of one skydiver’s reserve parachute became entangled on a protruding cabin door support bracket. The reserve chute deployed & was caught in the slip stream. The skydiver was then pulled from the open door. He impacted the right horizontal stabilizer, fell 4000 ft to the ground & was fatally injured. Most of the right stabilizer was torn from the aircraft. After its separation, the aircraft entered a dive & the remaining skydivers jumped from the plane.
Category: Fatal Multi-Engine
The acft was on a sport parachute flt to carry 24 parachutists to 12,500′ over a drop zone (dz) for a mass jump. It was in a cargo configuration with no passenger seats, but it had 1 jump seat. There were 24 seat belts on the floor of the cargo area. Also, the cabin door had been removed & an unapproved step & 4 handholds were installed outside & forward of the cabin door for parachutists. The usual jump-run procedure was for the acft to be slowed to 95 to 100 kts, extend the gear & apch flaps & reduce power on the left eng. The jumpers remained in position without using seat belts until apchg the dz, then 2 moved outside the acft while others moved close to the doorway. The 1st jumpers were unaware of anyproblem, but saw the acft enter a steep bank, roll over & spiral nose down. 16 jumpers exited the acft, but 3 hit the stabilizer. The acft crashed in a near vertical dscnt. Investigation revealed the cg was behind the aft limit for takeoff & the jump. The elevator trim actuator was found in a position for full nose-up trim.
Three observers accompanied the aircrew & other passengers on a flt to transport skydivers aloft. Prior to the flt, all 3 of the observers were briefed not to exit the acft until the engines were secured. However, 1 of the 3 discussed the need to move a cessna 172 at the completion of the flt. After returning from the flt, the aircrew stopped the plane on the ramp. While the engines were still running, the occupant that wanted to move the cessna exited the acft. Unbeknown to him & the plt, the other 2 occupants also exited the acft. One of them walked into the arc of the left propeller & received a fatal head injury.
The aircraft was on a local flight involving a parachute jumping activity. In addition to the pilot, there were 12 parachutists and an observer on board. The pilot initiated his takeoff on runway 18. A witness stated that shortly after takeoff, the engine power was reduced to climb power, followed by the gear retraction. Reportedly, the aircraft had climbed to about 150 ft agl when the nose pitched up, th plane rolled to the left and then it crashed in a steep left bank, nose down attitude. An investigation revealed that the aircraft was loaded well beyond its maximum gross weight and aft cg limits. The amount of fuel on board was not verified, but even with no fuel, the plane would have been about 580 lbs over the maximum limit. With 100 gallons, the estimated gross weight would have been about 9939 lbs with the cg at about 121 inches. The maximum certificated gross weight was 8750 lbs with an aft cg limit of 117.6 inches. Extensive ground fire damage, but no preimpact, mechanical discrepancies evident.